MEM Eaton TPN Switch Disconnectors

MEM Eaton 15AXTN2 surface mounted switch in grey
Limited stock available
Price: £43.00 in stock Quantity:




NOTE - These are switches ''only'' there are no fuses in them.

15AXTN2 - (2 Available)
100AXTN2 - (0 Available)

These MEM Eaton Switch Disconnectors are surface mounted enclosures with chrome plated front switching handle with ON - OFF indicators and lock on - lock off facility (padlock not supplied), they are manufactured from rust protected sheet steel and have a painted grey finish.

Removable plates with knockouts are fixed to the top and bottom and the hinged screw down lid with gasket gives IP41 protection. They have plain flat sides allowing them to be mounted close to other units making for a compact configuration and maximising use of limited space.

The unit has been designed with the installer in mind and although compact, ample space has been provided for both incoming and outgoing cables. There are four pre-drilled raised fixing holes to the rear allowing the unit to stand slightly off the wall.

The switches have been type tested and meet isolation construction requirements as required in BS EN60947-3. They have moving contact assemblies that can be removed to assist with wiring, a quick make and break design and can be used on AC or DC. The motor rating is utilization category AC23A to BS EN60947-3 which requires a make and break test at 10 and 8 times the rated current for units with a motor rating up to 100 amps.

IMPORTANT - The above items are new but the products boxes have been damaged and the units cover fixing screws have a slight discolouration, so they are for sale at a special discounted price.

15 Amp = Height 159mm x Width 193mm x Depth 92mm (Depth 127mm inc handle)
30 Amp = Height 173mm x Width 245mm x Depth 101mm (Depth 137mm inc handle)
100 Amp = Height 329mm x Width 367mm x Depth 167mm (Depth 210 mm inc handle)

 

This is the basket Message

This is the basket Message